● Using PT pump technology ● Low fuel consumption ● Stable and reliable performance ● Simple and convenient maintenance ● Long service life, low exhaust air ● emissions to meet the three European standards

1. After the diesel generator is shut down, pay attention to check whether the diesel generator has "three leakage" phenomenon, lubricating oil, fuel oil, coolant 2. Turn off the fuel valve 3. Turn off the air inlet and exhaust facilities in the equipment room 4. Turn off the generator output circuit breaker 5. 6. When the diesel generator set is shut down for a long time or the unit is being maintained, the negative cable of the starting battery of the diesel generator set must be removed, and the fuel oil and coolant should be drained if necessary.

advantages

As a mature technology, the advantages of clean and modern Cummins generator sets are:

1. Rapid product supply

2. High reliability and low life cycle cost

3. Efficiency and operational flexibility

4. High quality electrical performance

5. Good service and fuel supply infrastructure

6. It can be integrated in the factory for use in high-displacement and environmentally sensitive locations.

The 7.7.5 kW to 25 kW air - or liquid-cooled diesel generator sets provide traditional structural robustness, durability and reliability for a wide range of applications, providing prime power for remote or temporary sites.

8. From 35 kW to 500 kW, diesel-fueled Cummins generator sets provide backup power or integrated systems that can add programmatic features to your specific application. The generator sets are widely used.

9. In the range of 600 kW to 2.7 MW, diesel-fueled Cummins generator sets can meet your demanding needs.

1. After several generators are parallel, a large power generator can supply power to the load. According to the size of the load, several machines can be decided to open (the unit consumes oil at 75% of the rated load), so as to save diesel and reduce the cost of the generator.

2. Realize uninterruptible power supply to ensure normal production of the factory. When the unit is converted to use, the standby unit can be started first, and then the original operating unit can be stopped.

3, multiple units and linkage line, when the load suddenly increases, the current impact is shared by multiple units, so that each unit force reduction, stable voltage and frequency, can extend the service life of the unit.